February 16, 2017

[2017 Hot] Updated New Cisco 300-135 Dumps and 300-135 Exam Video Online

300-135 dumps

300-135 Exam Description
Subscribe to Cisco Learning Network Premium and access the most comprehensive e-learning training, resources and tools you’ll need to prepare for your CCENT, CCNA and CCNP Routing and Switching certifications.The following topics are general guidelines for the content that is likely to be included on the exam. However, other related topics may also appear on any specific version of the 300-135 dumps. To better reflect the contents of the exam and for clarity, the following guidelines may change at any time without notice.

1.0 Network Principles 5%
2.0 Layer 2 Technologies 40%
3.0 Layer 3 Technologies 40%
3.2 Troubleshoot IPv6 addressing and subnetting
4.0 VPN Technologies 5%
5.0 Infrastructure Security 5%
6.0 Infrastructure Services 5%
Exam Information: https://www.pass4itsure.com/300-135.html

Although more and more people sign up to attend Cisco 300-135 TSHOOT Exam Real Dumps, the official did not reduce its difficulty and it is still difficult to pass the exam. After all, this is an authoritative test to inspect the computer professional knowledge and information technology ability. In order to pass the Cisco certification 300-135 exam, generally, many people need to spend a lot of time and effort to review.

QUESTION 3
A customer network engineer has made configuration changes that have resulted in some loss of connectivity. You have been called in to evaluate a switch network and suggest resolutions to the problems.

You have configured PVST+ load balancing between SW1 and the New_Switch in such a way that both the links E2/2 and E2/3 are utilized for traffic flow, which component of the configuration is preventing PVST+ load balancing between SW1 and SW2 links
A. Port priority configuration on SW1
B. Port priority configuration on the New_Switch
C. Path cost configuration on SW1
D. Path cost configuration on the New_Switch Correct Answer: D
Explanation Explanation/Reference:
Explanation:
Here is the configuration found on the New_Switch:
This causes the port cost for link eth 1/3 to increase the path cost to 250 for all VLANs, making that link less preferred so that only eth 1/2 will be used.
QUESTION 4
A customer network engineer has made configuration changes that have resulted in some loss of connectivity. You have been called in to evaluate a switch network and suggest resolutions to the problems.

Refer to the topology.
SW1 Switch Management IP address is not pingable from SW4. What could be the issue?

A. Management VLAN not allowed in the trunk links between SW1 and SW4
B. Management VLAN not allowed in the trunk links between SW1 and SW2
C. Management VLAN not allowed in the trunk link between SW2 and SW4
D. Management VLAN ip address on SW4 is configured in wrong subnet
E. Management VLAN interface is shutdown on SW4 Correct Answer: D
Explanation Explanation/Reference:
Explanation:
In the network, VLAN 300 is called the Management VLAN. Based on the configurations shown below, SW1 has VLAN 300 configured with the IP address of 192.168.10.1/24, while on SW4 VLAN 300 has an IP address of 192.168.100.4/24, which is not in the same subnet.

Exam A
QUESTION 1
01. What is the purpose of validuser ACL ?
A. When a user transmits data through the controller, the validuser ACL is used to check if the user is in the layer 3 user-table.
B. Before a client is added to the controller’s user table, the validuser ACL is checked to make sure the client has a valid IP address.
C. The validuser ACL is used during 802.1X authentication to check that the client is in the layer 3 user-table.
D. When an AP needs to transmit data to a user , it ckecks the validuser ACL to make sure the user has valid IP Address.

Correct Answer: B Section: (none) Explanation
Explanation/Reference:
QUESTION 2
02. What is necessary for the controller to layer 3 switch user traffic ? (Choose all that apply)
A. The controller must be the DHCP server.
B. The controller must be the default gateway for the user.
C. An external router must be used as the user default gateway.
D. The controller must have IP addresses assigned to appropriate WLANs.

Correct Answer: BD Section: (none)Explanation
Explanation/Reference:
QUESTION 3
03. Which of the following is true of an Aruba Mobility Controller acting as a layer 2 switch ? (select all the apply)
A. The Mobility Controller is the client’s default router.
B. The mobility Controller acts as a bridge.
C. All stations must use the same VLAN.
D. Uplink ports of the Mobility Controller cab use 802.1q tagging.

Correct Answer: BD Section: (none)Explanation
Explanation/Reference:
QUESTION 4
04. Which Firewall action is necessary in the guest pre-authentication role to display the captive portal login screen ?
A. SRC-NAT
B. DST-NAT
C. allow all D. allow CP

Correct Answer: D Section: (none) Explanation
Explanation/Reference:
QUESTION 5
05. Remote AP in tunnel mode, by default, uses the following to encrypt user traffic back to the mobility controller:
A. L2TP over IPSec is used to carry user traffic and control traffic.
B. PPTP is used to tunnel user traffic.
C. The AP does not encrypt user traffic. The user’s link layer encrypt is used.
D. Remote AP traffic is unencrypted.

Correct Answer: C Section: (none) Explanation
Explanation/Reference:
QUESTION 6
06. Clients connecting to remote AP at a branch office can get an IP address througn which of the following methods ? (Select all the apply)
A. DHCP server connected to the Remote AP’s controller.
B. DHCP server at the branch office
C. DHCP server inside the Remote AP
D. All the above.

Correct Answer: D Section: (none) Explanation
Explanation/Reference:
QUESTION 7
07. Which of the following is not available for configuration in the startup wizard?
A. RF Plan.
B. Administrator and enable passwords.
C. Native VLANs on a per port basis
D. WPA-PSK encryption.

Correct Answer: A Section: (none)Explanation: lead4pass promo code:

Explanation/Reference:
QUESTION 8
08. What type of authentication servers are selectable in the WLAN wizard (choose all the apply):
A. RADIUS
B. Kerberos
C. LDAP
D. Internal database

Correct Answer: AD Section: (none)Explanation
Explanation/Reference:
QUESTION 9
09. Order The following steps from 1-4 for the AP boot process:
Select and Place:

Correct Answer:
Section: (none) Explanation
Explanation/Reference:
QUESTION 10
10. Firewall rules contain the following fields , except (choose one)
A. Action
B. Destination
C. Service
D. Policy

Correct Answer: D Section: (none)Explanation
Explanation/Reference:

300-135 dumps

Pass4itsure guarantee exam success rate of 100% ratio, except no one. You choose Pass4itsure, and select the training you want to start, you will get the best resources with market and reliability assurance.With Pass4itsure Cisco 300-135 TSHOOT Exam Real Dumps you can pass the Cisco 300-135 pdf easily. The training tools which designed by our website can help you pass the exam the first time. You only need to download the Pass4itsure Cisco 300-135 vce, the exam will become very easy. Pass4itsure guarantee that you will be able to pass the exam.

This shows Pass4itsure cisco 300-135 TSHOOT exam real dumps can indeed help the candidates to pass the exam. Compared to other questions providers, Pass4itsure cisco 300-135 TSHOOT exam real dumps have been far ahead.Pass4itsure cisco 300-135 online test questions praised by the majority of candidates is not a recent thing. This shows Pass4itsure cisco 300-135 dumps can indeed help the candidates to pass the exam.

For More Details: http://www.cert4sure.net/pass-reliable-cisco-210-060-pdf-exam-with-full-confidence.html